LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (Wiring Diagram Information) >> Diode >> Installation

Section 67 (Wiring Diagram Information): Diode: Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the insulation from the wires in the harness. Only remove enough insulation to solder in the new diode.
  2. Install the new diode in the harness, making sure current flow is correct. If necessary, refer to the appropriate SYSTEM WIRING DIAGRAMS article for current flow.
  3. Solder the connection together using rosin core type solder only. Do not use acid core solder. 
  4. Tape the diode to the harness using electrical tape. Make sure the diode is completely sealed from the elements.
  5. Re-connect the battery and test affected systems.
scientia non olet · About LEMON Manuals