LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (DTCS U0151 To U1415, Seat Weight Sensor Diagnosis & Verification Tests) >> Diagnosis And Testing >> *OCS Verification Test - VER 1 >> Additional Wiring

Additional Wiring

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

For a complete wiring diagram refer to appropriate SYSTEM WIRING DIAGRAMS article.

1. Remove any special tools or jumper wires and reconnect all previously disconnected components - except the Battery.

WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNITION ON THEN RECONNECT THE BATTERY.

2. Connect the scan tool to the Data Link Connector - use the most current software available.

3. With the scan tool to erase stored DTCs in all airbag system modules.

4. Turn the ignition off, and wait 15 seconds, then turn the ignition on.

5. Wait one minute, and read active codes and if there are none present read the stored codes.

6. Note: Read the DTC's in all airbag system related modules.

7. If the scan tool shows any active or stored codes, return to the DIAGNOSTIC CODE INDEX and follow path specified for that trouble code. If no active or stored codes are present, the repair is complete.

Are any DTC's present or is the original condition still present? 

Yes 

  1. Repair is not complete, refer to appropriate symptom list.

No 

  1. Repair is complete.
scientia non olet · About LEMON Manuals