LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Vehicle Theft Security System (Service Information)) >> Intrusion Sensor - Export >> Removal >> Receiver

Intrusion Sensor - Export: Removal: Receiver

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Receiver
GC0040906Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate the battery negative cable.
  2. Remove the overhead console from the headliner. (Refer to ELECTRICAL/OVERHEAD CONSOLE - REMOVAL) .
  3. Disconnect the electrical connector (5) on the receiver housing.
  4. Release the three latch features (2) of the mounting bracket and disengage the receiver from the bracket.
scientia non olet · About LEMON Manuals