LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Vehicle Theft Security System (Service Information)) >> Hood Ajar Switch - Export >> Installation

Hood Ajar Switch - Export: Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Self-adjustment of the hood ajar switch is a one-time feature. If the switch is damaged, ineffective, removed or requires readjustment, it must be replaced with a new unit.
  1. Position the hood ajar switch near the hole in the mounting bracket.
  2. Pull the wire harness connector through the switch mounting bracket and reconnect it to the switch.
  3. From the top of the mounting bracket, press the switch downward into the mounting hole until the integral switch latch tabs lock it into place.
  4. Reconnect the battery negative cable.
  5. Close and latch the hood. This will adjust the hood ajar switch to the proper height.
scientia non olet · About LEMON Manuals