LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Charging System) >> Generator >> Installation >> 6.1L >> Rear Wheel Drive (RWD)

Rear Wheel Drive (RWD)

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Generator
GC0015638Courtesy of DAIMLERCHRYSLER CORP.
  1. Position generator (2) to engine and install 2 mounting bolts (1). Do not tighten bolts (1) at this time.
  2. Raise and support vehicle.
    Fig 2: Disconnecting/Connecting Generator Support Bracket
    GC0015639Courtesy of DAIMLERCHRYSLER CORP.
  3. Position support bracket (1) to generator and install bolt (3). Tighten all bolts / nut. Refer to SPECIFICATIONS .
    Fig 3: Engine Mount Heat Shield - 6.1L
    GC0040667Courtesy of DAIMLERCHRYSLER CORP.
  4. Install heat shield (1) and two heat shield mounting bolts (2).
  5. Snap field wire connector into rear of generator.
  6. Install B+ terminal eyelet to generator output stud. Tighten mounting nut. Refer to SPECIFICATIONS .
  7. Lower vehicle.
    CAUTION: Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.
    CAUTION: When installing a serpentine accessory drive belt, the belt MUST be routed correctly. The water pump may be rotating in the wrong direction if the belt is installed incorrectly, causing the engine to overheat. Refer to belt routing label in engine compartment, or refer to Belt Schematics in COOLING .
  8. Install generator drive belt. Refer to COOLING for procedure.
  9. Install upper radiator hose and fill cooling system with coolant.
  10. Install negative battery cable to battery.
scientia non olet · About LEMON Manuals