Diagnostic Test
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- 1) DETERMINING IF DTC IS CURRENT NOTE: Diagnose any related Communication DTC(s) before continuing.
With a scan tool, read and record DTC(s).
With the scan tool, clear DTC(s).
Turn the ignition off and remove the key from the ignition.
Lock and close all doors to allow the VTSS to go from pre-arm to armed status and wait one minute.
Disarm the VTSS.
Using the scan tool, read DTC(s).
Does the DTC reset?
Yes
- Check for and correct any CAN B Bus DTC's set in the ITM or other modules. Also check for intermittent loss Fused B(+) to the ITM.
- Perform BODY VERIFICATION TEST - VER 1 (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)
No
- DTC is not active at this time. Test complete.
- Perform BODY VERIFICATION TEST - VER 1 (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE)