LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Vehicle Theft Security System - Electrical Diagnostics) >> Vehicle Theft Security - Electrical Diagnostics >> DTC Troubleshooting >> B1A24-Key Not Programmed >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. 1)  PROGRAM ALL OF THE IGNITION KEYS 

    Turn the ignition on.

    With the scan tool, attempt to program the key(s) into the SKREEM.

    Was the programming of the key(s) successful? 

    Yes 

    1. Perform SKREEM VERIFICATION TEST. (Refer to ELECTRICAL/VEHICLE THEFT SECURITY - STANDARD PROCEDURE) 

    No 

    1. Replace the ignition key and attempt to program it into the SKREEM. If the DTC resets, replace and program the SKREEM in accordance with the Service Information.
      NOTE: If this vehicle is equipped with a Steering Column Lock Module, it must be replaced along with the SKREEM.
    2. Perform SKREEM VERIFICATION TEST. (Refer to ELECTRICAL/VEHICLE THEFT SECURITY - STANDARD PROCEDURE) 
scientia non olet · About LEMON Manuals