LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Engine Controls - DTCS P0585 To P0688) >> Diagnosis And Testing >> P0632-Odometer Not Programmed In Pcm >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. 1)  PROGRAMMING MILEAGE INTO THE PCM 

    Ignition on, engine not running.

    With the scan tool, erase DTCs.

    Using a scan tool, program the mileage into the PCM.

    Start the engine.

    Allow the engine to reach normal operating temperature.

    With a scan tool, read DTCs.

    Does the DTC reset? 

    Yes 

    1. Replace and program the Powertrain Control Module per Service Information.
    2. Perform POWERTRAIN VERIFICATION TEST .

    No 

    1. The mileage has been successfully programmed into the PCM. Test is complete.
    2. Perform POWERTRAIN VERIFICATION TEST .
scientia non olet · About LEMON Manuals