LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Engine Controls - DTCS P0585 To P0688) >> Diagnosis And Testing >> P060F-Etc Level 2 ECT Performance >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. 1)  PROGRAM THE POWERTRAIN CONTROL MODULE 
    NOTE: Diagnose any Engine Coolant Temperature Sensor DTCs before continuing.

    Verify the PCM is at the latest calibration (flash level).

    NOTE: An intermittent loss of power to the PCM without performing an ETC Relearn procedure may cause this DTC to set.

    Flash the Powertrain Control Module per Service Information if any updates are available.

    Start the engine.

    Allow the engine to reach normal operating temperature.

    Operate the accelerator pedal. (do not exceed 3500 RPM)

    With a scan tool, read DTCs.

    NOTE: Diagnose any other DTCs that may have set with the P060F.

    Does this DTC reset by itself? 

    Yes 

    1. Replace and reprogram the Powertrain Control Module per Service Information.
    2. Perform POWERTRAIN VERIFICATION TEST .

    No 

    1. Test Complete.
scientia non olet · About LEMON Manuals