LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (HVAC System (Service Information)) >> Plumbing >> Line-A/C Liquid >> Installation >> Front Section

Front Section

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Remove/Install A/C Liquid Line - Front
GC0014001Courtesy of DAIMLERCHRYSLER CORP.
NOTE: LHD model shown. RHD model similar.
  1. Position the front section of the liquid line (2) into the engine compartment.
  2. Remove the tape or plugs from the fittings that connect the front section of the A/C liquid line to the rear section of the A/C liquid line (3).
  3. Lubricate a new dual plane seal with clean refrigerant oil and install it onto the liquid line fitting. Use only the specified seal as it is made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
  4. Connect the front section of the A/C liquid line to the rear section of the A/C liquid line.
  5. Install the nut (1) that secures the front section of the A/C liquid line to the rear section of the A/C liquid line. Tighten the nut to 22 N.m (16 ft. lbs.).
    Fig 2: Removing/Installing A/C Lines at Condenser
    GC0013999Courtesy of DAIMLERCHRYSLER CORP.
  6. Raise and support the vehicle.
  7. Remove the tape or plugs from the fitting on the front section of the A/C liquid line (4) and the outlet port of the A/C condenser (5).
  8. Lubricate a new dual plane seal with clean refrigerant oil and install it onto the liquid line fitting. Use only the specified seal as it is made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
  9. Connect the A/C liquid line to the A/C condenser.
  10. Install the nut (3) that secures the front section of the A/C liquid line to the A/C condenser. Tighten the nut to 22 N.m (16 ft. lbs.).
  11. Install the front end belly pan (Refer to INSTALLATION .
  12. Lower the vehicle.
  13. Install the air cleaner housing (refer to appropriate ENGINE SERVICE INFORMATION article.
  14. Reconnect the negative battery cable.
  15. Evacuate the refrigerant system (Refer to REFRIGERANT SYSTEM EVACUATE ).
  16. Charge the refrigerant system (Refer to REFRIGERANT SYSTEM CHARGE ).
scientia non olet · About LEMON Manuals