LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (HVAC System (Service Information)) >> Plumbing >> Evaporator-A/C >> Removal

Section 46 (HVAC System (Service Information)): Plumbing: Evaporator-A/C: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Remove/Install Evaporator-A/C
GC0013975Courtesy of DAIMLERCHRYSLER CORP.
NOTE: LHD model shown. RHD model similar.
  1. Remove the HVAC housing assembly (Refer to HEATING & AIR CONDITIONING/DISTRIBUTION/HOUSING-HVAC - HOUSING-HVAC ASSEMBLY - REMOVAL) .
  2. Disassemble the HVAC housing as necessary to access the A/C evaporator (1) (Refer to HEATING & AIR CONDITIONING/DISTRIBUTION/HOUSING-HVAC - DISASSEMBLY) .
  3. Carefully lift the A/C evaporator and the foam seal (2) out of the lower half of the HVAC housing (3).
  4. If required, remove the foam seal from the tapping block of the A/C evaporator. If the seal is deformed or damaged, it must be replaced.
scientia non olet · About LEMON Manuals