Section 46 (HVAC System (Service Information)): Distribution: Motor-Blower: Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Remove/Install Motor-A/C Blower

Courtesy of DAIMLERCHRYSLER CORP.

NOTE: LHD model shown. RHD model similar.

Position the blower motor (2) into the HVAC housing (4).
Install the four screws (3) that secure the blower motor to the HVAC housing. Tighten the screws to 2.2 N.m (20 in. lbs.).
Connect the wire harness connector (1) to the blower motor and engage the wire harness connector locking tab.
Install the HVAC wire harness retainers onto the blower motor.
Install the instrument panel silencer onto the passenger side of the instrument panel (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL SILENCER - INSTALLATION)
Reconnect the negative battery cable.