Housing-Air Inlet
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The air inlet housing must be removed from HVAC housing and disassembled for service of the recirculation-air door.
NOTE:
LHD model shown. RHD model similar.
- Remove the air inlet housing (1) from the HVAC housing and place it on a workbench (Refer to HOUSING-AIR INLET ).
- Remove the three screws (2) that secure the recirculation door actuator (3) to the air inlet housing and remove the actuator.
- Remove the recirculation-air door (4) from the air inlet housing.