Intermediate Floor Distribution Ducts
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
LHD model shown. RHD model similar.
- Remove the center floor console (Refer to BODY/INTERIOR/FLOOR CONSOLE - REMOVAL) .
- Remove the front seats (Refer to BODY/SEATS/SEAT - REMOVAL) .
- Roll back the front floor carpet from under the instrument panel toward the rear of the vehicle (Refer to BODY/INTERIOR/CARPETS AND FLOOR MATS - REMOVAL) .
- Remove the push pin fastener (1) that secures the passenger side front intermediate floor distribution duct (2) to the floor support (4).
- Disconnect the passenger side front intermediate floor distribution duct from the front floor distribution duct (8).
- Disconnect the passenger side front intermediate floor distribution duct from the passenger side rear intermediate floor distribution duct (3).
- Remove the passenger side rear intermediate floor distribution duct from the floor support.
- Remove the push pin fastener (6) that secures the driver side rear intermediate floor distribution duct (5) to the floor support.
- Disconnect the driver side front intermediate floor distribution duct (7) from the front floor distribution duct.
- Disconnect the driver side front intermediate floor distribution duct from the driver side rear intermediate floor distribution duct.
- Remove the driver side rear intermediate floor distribution duct from the floor support.