LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (HVAC System (Service Information)) >> Controls >> Transducer-A/C Pressure >> Removal

Transducer-A/C Pressure: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: It is not necessary to discharge the refrigerant system to replace the A/C pressure transducer.
Fig 1: Remove/Install A/C Pressure Transducer
GC0013944Courtesy of DAIMLERCHRYSLER CORP.
NOTE: LHD model shown. RHD model similar.
  1. Disconnect and isolate the negative battery cable.
  2. Disconnect the wire harness connector (1) from the A/C pressure transducer (2).
  3. Remove the A/C pressure transducer from the A/C liquid line (3) and remove and discard the O-ring seal.
scientia non olet · About LEMON Manuals