LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (HVAC System (Service Information)) >> Controls >> Transducer-A/C Pressure >> Installation

Transducer-A/C Pressure: Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Use only the specified O-ring as it is made of special material for R-134a. Use only refrigerant oil of the type required for the A/C compressor.
Fig 1: Remove/Install A/C Pressure Transducer
GC0013944Courtesy of DAIMLERCHRYSLER CORP.
NOTE: LHD model shown. RHD model similar.
  1. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it onto the liquid line fitting.
  2. Install the A/C pressure transducer (2) onto the A/C liquid line (3). Tighten the A/C pressure transducer securely.
  3. Connect the wire harness connector (1) to the A/C pressure transducer.
  4. Reconnect the negative battery cable.
scientia non olet · About LEMON Manuals