LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 ((HVAC Systems - Electrical Diagnostics)) >> Electrical Diagnostics >> DTC Troubleshooting >> B1016-Rear Defrost Switch Request Input Circuit Low (ATC) >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. 1)  INSPECT THE A/C HEATER CONTROL FOR DAMAGE 

    Inspect the A/C Heater Control for damage.

    Is the A/C Heater Control damaged? 

    Yes 

    1. Replace the A/C Heater Control in accordance with the Service Information.
    2. Perform BODY VERIFICATION TEST - VER 1. (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES/FRONT CONTROL MODULE - DIAGNOSIS AND TESTING) .

    No 

    1. Go To step  2).
  2. 2)  INSPECT FOR OBJECT OR SUBSTANCE CAUSING THE EBL MODE SWITCH TO STAY OR STICK IN A PUSHED POSITION 

    Inspect the A/C Heater Control for anything that would cause the EBL mode switch to stay or stick in a pushed position.

    Is anything present that would cause the EBL mode switch to stay or stick in a pushed position? 

    Yes 

    1. Repair as necessary.
    2. Perform BODY VERIFICATION TEST - VER 1. (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES/FRONT CONTROL MODULE - DIAGNOSIS AND TESTING) .

    No 

    1. Go To step  3).
  3. 3)  CHECK FOR NORMAL EBL MODE SWITCH & STATUS INDICATOR FUNCTION 

    Turn the ignition on.

    Press the EBL mode switch on and off several times while observing the EBL status indicator.

    Does the EBL status indicator turn on and off? 

    Yes  

    1. Go To step  4).

    No  

    1. Replace the A/C Heater Control in accordance with the Service Information.
    2. Perform BODY VERIFICATION TEST - VER 1. (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES/FRONT CONTROL MODULE - DIAGNOSIS AND TESTING) .
  4. 4)  VERIFY THAT DTC B1016-REAR DEFROST SWITCH REQUEST INPUT CIRCUIT LOW IS STILL ACTIVE 

    With the scan tool, erase HVAC DTCs.

    Turn the ignition off, wait 10 seconds, and then turn the ignition on. Wait 10 minutes before proceeding.

    With the scan tool, read HVAC DTCs.

    Does the scan tool display active: B1016-REAR DEFROST SWITCH REQUEST INPUT CIRCUIT LOW? 

    Yes 

    1. Replace the A/C Heater Control in accordance with the Service Information.
    2. Perform BODY VERIFICATION TEST - VER 1. (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES/FRONT CONTROL MODULE - DIAGNOSIS AND TESTING) .

    No 

    1. Perform BODY VERIFICATION TEST - VER 1. (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES/FRONT CONTROL MODULE - DIAGNOSIS AND TESTING) .
scientia non olet · About LEMON Manuals