Section 44 (Power Top & Sunroof (Service Information)): Motor/Module-Sunroof: Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: The Excessive Force Limitation (EFL) feature must be calibrated any time a sunroof motor/module is replaced with a new component. Failure to perform this procedure could result in vehicle damage and/or personal injury. Refer toEXCESSIVE FORCE LIMITATION (EFL) CALIBRATION for the appropriate procedure.

Fig 1: Locating Sunroof Motor/Module

Courtesy of DAIMLERCHRYSLER CORP.

Position the power sunroof motor/module (1) in the vehicle.
Install the motor/module retaining screws (3). Tighten the screws to 4 N.m (35 in. lbs.).
Connect the motor/module electrical connector (2).
Connect the battery negative cable and move the sunroof through one open and close cycle to confirm proper system operation.
Install the vehicle headliner, (Refer to BODY/INTERIOR/HEADLINER - INSTALLATION) .
Perform the sunroof position calibration, refer to SUNROOF POSITION CALIBRATION .
Perform the Excessive Force Limitation (EFL) calibration, refer toEXCESSIVE FORCE LIMITATION (EFL) CALIBRATION .
Verify proper operation of the power sunroof system.