Switch-Remote Radio: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Right Radio Switch

Courtesy of DAIMLERCHRYSLER CORP.

NOTE: A battery reconnect procedure must be performed anytime the battery has been disconnected. (Refer to ELECTRICAL/BATTERY SYSTEM - STANDARD PROCEDURE) .

Disconnect and isolate the battery negative cable.
Remove the driver airbag (Refer to ELECTRICAL/RESTRAINTS/DRIVER AIRBAG - REMOVAL) .
Using a trim stick, gently pry switch from steering wheel at locations shown in Fig 1.
Disconnect electrical connector.
Remove switch from steering wheel.