LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Audio System (Service Information)) >> Antenna Cable >> Installation

Antenna Cable: Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: A battery reconnect procedure must be performed anytime the battery has been disconnected. (Refer to ELECTRICAL/BATTERY SYSTEM - STANDARD PROCEDURE) .
  1. Position antenna cable and secure to wire harness.
  2. Connect antenna cable to antenna module.
  3. Connect antenna cable to instrument panel antenna cable.
  4. Install right side C-pillar trim panel (Refer to BODY/INTERIOR/C-PILLAR TRIM - INSTALLATION) .
  5. Install right side front and rear door scuff plates (Refer to BODY/INTERIOR/DOOR SILL SCUFF PLATE - INSTALLATION) .
  6. Install right side cowl trim panel.
  7. Connect battery negative cable.
scientia non olet · About LEMON Manuals