LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Steering System (Service Information)) >> Pump >> Reservoir >> Removal

Section 38 (Steering System (Service Information)): Pump: Reservoir: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Disconnecting/Connecting Battery Cables
GC0012970Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate battery negative cable (2) from battery post.
  2. Siphon power steering fluid from pump reservoir.
  3. Remove air cleaner housing and inlet tube to throttle body. Refer to appropriate ENGINE - SERVICE INFORMATION article.
    Fig 2: Removing/Installing Remote Reservoir
    GC0013315Courtesy of DAIMLERCHRYSLER CORP.
  4. Remove hose clamp, then supply hose (3) at reservoir (2).
  5. Remove hose clamp, then return hose (1) at reservoir (2).
  6. Remove reservoir (2) from coolant bottle (4) by sliding it out of guide.
scientia non olet · About LEMON Manuals