LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Steering System (Service Information)) >> Pump >> Removal >> 5.7L/6.1L

Section 38 (Steering System (Service Information)): Pump: Removal: 5.7L/6.1L

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Disconnecting/Connecting Battery Cables
GC0012970Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate battery negative cable (2) from battery post.
  2. Siphon power steering fluid from pump reservoir.
  3. Remove air cleaner housing and inlet tube to throttle body. Refer to REMOVAL and REMOVAL .
  4. Remove serpentine drive belt. (Refer to COOLING/ACCESSORY DRIVE/DRIVE BELTS - REMOVAL)
    Fig 2: Remove/Install Supply Hose - 5.7L/6.1L
    GC0013307Courtesy of DAIMLERCHRYSLER CORP.
  5. Remove hose clamp, then supply hose (3) from pump (1).
    Fig 3: Remove/Install Pressure Hose at Pump - 5.7L/6.1L
    GC0013306Courtesy of DAIMLERCHRYSLER CORP.
  6. Unthread tube nut, then remove pressure hose (2) from pump (1).
    Fig 4: Remove/Install Power Steering Pump - 5.7L/6.1L
    GC0013305Courtesy of DAIMLERCHRYSLER CORP.
  7. Remove three pump mounting bolts (2) through access holes in pulley.
  8. Remove pump (1) from engine.
  9. If pulley needs removal, (Refer to STEERING/PUMP/PULLEY - REMOVAL) .
scientia non olet · About LEMON Manuals