3.0L Diesel

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Disconnecting/Connecting Battery Cables

Courtesy of DAIMLERCHRYSLER CORP.

Disconnect and isolate battery negative cable (2) from battery post.
Remove engine cover.
Remove air cleaner housing and inlet tube to throttle body. Refer to ENGINE - SERVICE INFORMATION article
Remove turbocharger inlet tube.
Remove intercooler tube resonator.
Remove serpentine drive belt. (Refer to COOLING/ACCESSORY DRIVE/DRIVE BELTS - REMOVAL)
Siphon power steering fluid from pump reservoir. Place something below pump on belly pan to catch any fluid that spills during removal.

Fig 2: SUPPLY HOSE - 3.0L DIESEL
Courtesy of DAIMLERCHRYSLER CORP.
Remove hose clamp (2), then supply hose (3) from pump (1).

Fig 3: Pressure Hose At Pump
Courtesy of DAIMLERCHRYSLER CORP.
Unthread tube nut (2), then remove pressure hose from pump (1).

Fig 4: POWER STEERING PUMP - 3.0L DIESEL
Courtesy of DAIMLERCHRYSLER CORP.
Loosen, but do not remove, two pump mounting bolts (1) through access holes in pulley.

Fig 5: PUMP MOUNTING BRACKETS - 3.0L DIESEL
Courtesy of DAIMLERCHRYSLER CORP.
Loosen, but do not remove, two mounting bolts (4) fastening front pump mounting bracket (1) to engine.

Fig 6: POWER STEERING PUMP - 3.0L DIESEL
Courtesy of DAIMLERCHRYSLER CORP.
Remove two previously loosened pump mounting bolts (1) and remove power steering pump (2) from engine.

NOTE: The drive pulley is not serviced separately from the power steering pump.