Hose - Supply: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Disconnecting/Connecting Battery Cables

Courtesy of DAIMLERCHRYSLER CORP.

Disconnect and isolate battery negative cable (2) from battery post.
Siphon power steering fluid from pump reservoir.
Remove air cleaner housing and inlet tube to throttle body. Refer to appropriate ENGINE - SERVICE INFORMATION article.

Fig 2: Remove/Install Supply Hose - 2.7L/3.5L
Courtesy of DAIMLERCHRYSLER CORP.
2.7L/3.5L Engines - Remove hose clamp (2), then supply hose (3) from pump (1).

Fig 3: Remove/Install Supply Hose - 5.7L/6.1L
Courtesy of DAIMLERCHRYSLER CORP.
5.7L/6.1L Engines - Remove hose clamp, then supply hose (3) from pump (1).

Fig 4: SUPPLY HOSE - 3.0L DIESEL
Courtesy of DAIMLERCHRYSLER CORP.
3.0L Diesel Engine - Remove hose clamp (2), then supply hose (3) from pump (1).

Fig 5: Removing/Installing Remote Reservoir
Courtesy of DAIMLERCHRYSLER CORP.
Remove hose clamp, then supply hose (3) at reservoir (2).
Remove supply hose from vehicle.