Hose - Supply: Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Remote Reservoir

Courtesy of DAIMLERCHRYSLER CORP.

Install reservoir end of supply hose (3) on reservoir hose fitting. Install clamp securing hose in place.

Fig 2: Remove/Install Supply Hose - 2.7L/3.5L
Courtesy of DAIMLERCHRYSLER CORP.
2.7L/3.5L Engines - Install supply hose (3) on pump. Install clamp (2) securing hose in place.

Fig 3: Remove/Install Supply Hose - 5.7L/6.1L
Courtesy of DAIMLERCHRYSLER CORP.
5.7L/6.1L Engines - Install supply hose (3) on pump (1). Install clamp securing hose in place.

Fig 4: SUPPLY HOSE - 3.0L DIESEL
Courtesy of DAIMLERCHRYSLER CORP.
3.0L Diesel Engine - Install supply hose (3) on pump (1). Install clamp (2) securing hose in place.
Install air cleaner housing and inlet tube. Refer to appropriate ENGINE - SERVICE INFORMATION article.

Fig 5: Disconnecting/Connecting Battery Cables
Courtesy of DAIMLERCHRYSLER CORP.
Connect battery negative cable (2) to battery post. It is important that this is performed properly. (Refer to ELECTRICAL/BATTERY SYSTEM - STANDARD PROCEDURE)
Fill pump reservoir with fluid and perform pump initial operation procedure. (Refer to STEERING/PUMP - STANDARD PROCEDURE)