Fluid Cooler - SRT8/Police Package

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Cooler Retainer Clips

Courtesy of DAIMLERCHRYSLER CORP.

Install center tube of cooler over mounting clips attached to cooling module. Push cooler past clip retaining tabs allowing it to lock into place.

Fig 2: SRT8 FLUID COOLER AND HOSES
Courtesy of DAIMLERCHRYSLER CORP.
Slide return hose to reservoir (3) onto outlet of cooler (2). Install clamp (4) securing hose in place.
Slide return hose from gear (5) onto inlet of cooler (2). Install clamp (1) securing hose in place.
Install belly pan. (Refer to BODY/EXTERIOR/BELLY PAN - INSTALLATION)
Lower vehicle.

Fig 3: Disconnecting/Connecting Battery Cables
Courtesy of DAIMLERCHRYSLER CORP.
Connect battery negative cable (2) to battery post. It is important that this is performed properly. (Refer to ELECTRICAL/BATTERY SYSTEM - STANDARD PROCEDURE)
Fill pump reservoir with fluid and perform pump initial operation procedure. (Refer to STEERING/PUMP - STANDARD PROCEDURE)