Tie Rod - Outer: Installation: RWD

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: When rotating inner tie rod, use care not to twist bellows at inner tie rod. Remove clamp at inner tie rod and make sure bellows moves freely before rotating inner tie rod.

Fig 1: Front Outer Tie Rod

Courtesy of DAIMLERCHRYSLER CORP.

Thread outer tie rod (5) onto inner tie rod (4), Install outer tie rod same number of turns as when removed.
Install outer tie rod end (5) into steering knuckle (2). Install and tighten nut (1) to 85 N.m (63 ft. lbs.) torque.

Fig 2: Tire And Wheel Mounting
Courtesy of DAIMLERCHRYSLER CORP.
Install tire and wheel assemblies (1). Tighten wheel mounting nuts (3) to 150 N.m (110 ft. lbs.) torque. (Refer to TIRES/WHEELS - INSTALLATION)
Lower vehicle.
Perform wheel alignment setting toe to specifications. (Refer to SUSPENSION/WHEEL ALIGNMENT - STANDARD PROCEDURE)

Fig 3: Front Outer Tie Rod
Courtesy of DAIMLERCHRYSLER CORP.
Tighten tie rod jam nut (3) to 75 N.m (55 ft. lbs.) torque.