LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Steering System (Service Information)) >> Column >> Wheel-Steering >> Removal

Section 38 (Steering System (Service Information)): Column: Wheel-Steering: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Before servicing the steering column the airbag system must be disarmed. Refer to RESTRAINTS - SERVICE INFORMATION for service procedures. Failure to do so may result in accidental deployment of the airbag and possible personal injury.
CAUTION: All fasteners must be torqued to specification to ensure proper operation of the steering column.
Fig 1: Removing/Installing Driver Airbag
GC0013236Courtesy of DAIMLERCHRYSLER CORP.
  1. Position the front wheels straight-ahead  .
  2. Fully extend or pull out adjustable steering column.
  3. Disconnect the negative (ground) cable from the battery.
  4. Remove the airbag (3). (Refer to ELECTRICAL/RESTRAINTS/DRIVER AIRBAG - REMOVAL) .
    Fig 2: Removing/Installing Steering Wheel
    GC0013237Courtesy of DAIMLERCHRYSLER CORP.
  5. Remove the steering wheel retainer bolt (2), then slide the steering wheel (1) off the shaft.
  6. If wheel is being replaced, transfer attached components as necessary.
scientia non olet · About LEMON Manuals