LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Chime & Buzzer (Service Information)) >> Module-Park Assist Display-Front >> Removal

Module-Park Assist Display-Front: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Remove/Install Park Assist Display
GC0015713Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate the battery negative cable.
  2. Lower the headliner (3) in the rear of the vehicle in the liftgate opening. Follow the headliner removal procedure for the rear of the headliner (Refer to BODY/INTERIOR/HEADLINER - REMOVAL) .
  3. Bend the retaining tabs (2) upwards to allow the park assist display (1) to drop out of the headliner (3) opening.
  4. Disconnect the display electrical connector (4) and remove display (1) from vehicle.
scientia non olet · About LEMON Manuals