LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Chime & Buzzer (Service Information)) >> Module-Park Assist Display-Front >> Installation

Module-Park Assist Display-Front: Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Remove/Install Park Assist Display
GC0015713Courtesy of DAIMLERCHRYSLER CORP.
  1. Position the Park Assist Display (1) in headliner (3) opening and connect the display electrical connector (4).
  2. Bend the retaining tabs (2) down behind the headliner (3).
  3. Raise the headliner in the rear of the vehicle in the liftgate opening (Refer to BODY/INTERIOR/HEADLINER - INSTALLATION) .
  4. Connect the battery negative cable.
scientia non olet · About LEMON Manuals