Section 36 (Frame & Bumpers): Bumper-Front: Removal
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
300 Shown. Magnum and Charger similar.
- Remove fascia assembly. (Refer to FRAME & BUMPERS/BUMPERS/FASCIA-FRONT - REMOVAL)
- Drill out the four spot welds (2 per side) between the bumper bracket and rail end cap (1).
- Remove the eight screws (4 per side) and remove the bumper.