Diagnostic Test

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

PCM ODOMETER MILEAGE NOT PROGRAMMED
1. Turn the ignition on.
2. With the scan tool, attempt to perform the Program PCM Odometer function.
3. With the scan tool, clear DTCs.
4. Start the engine.
5. Allow the engine to reach normal operating temperature.
6. With a scan tool, select View DTCs.
  Is the status Active for this DTC?
  
  Yes
  - Replace and program the Powertrain Control Module in accordance with the Service Information.
  - Perform the PCM Verification Test. See DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure
  No
  - The SRI mileage has been successfully programmed into the PCM. Test is complete.
  - Perform the PCM Verification Test. See DTC-Based Diagnostics/MODULE, Powertrain Control (PCM) - Standard Procedure