Diagnostic Test

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, record and erase DTC's
3. Move the seat switch in the horizontal position three times.
4. With the scan tool, read DTC's.
  Does the scan tool display B1D6E-SEAT HORIZONTAL POSITION SENSOR CIRCUIT HIGH?
  
  Yes
  - Go to step 2
  No
  - The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
  - Perform POWER SEAT SYSTEM VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Memory Seat (MSMD) - Standard Procedure .
CHECK THE (G401) DRIVER SEAT HORIZONTAL POSITION SENSE VOLTAGE
1. Disconnect the Driver Horizontal Seat Adjuster Motor.
  NOTE: Check connectors - Clean and repair as necessary.
2. With the scan tool erase DTC's
3. Move the seat switch in the horizontal positions three times.
4. With the scan tool, read DTC's.
  Does the same DTC reset?
  
  No
  - Inspect the position sense wire for a possible intermittent short to voltage from another circuit, if OK replace the Driver Horizontal Seat Adjuster Motor assembly.
  - Perform POWER SEAT SYSTEM VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Memory Seat (MSMD) - Standard Procedure .
  Yes
  - Inspect the position sense wire for a possible short to voltage from another circuit, if OK replace the Memory Seat Module.
  - Perform POWER SEAT SYSTEM VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Memory Seat (MSMD) - Standard Procedure .