Front Seat Belt Buckle

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Buckle

Courtesy of DAIMLERCHRYSLER CORP.

Position the front seat belt buckle onto the stud near the rear of the inboard seat cushion frame.
Install the retaining nut onto seat cushion frame. Tighten the nut to 43 N.m (32 ft. lbs.)
Connect the seat belt buckle electrical connector.
Install the seat cushion side shield.
Install floor console (Refer to BODY/INTERIOR/FLOOR CONSOLE - INSTALLATION) .

WARNING: Do not connect the battery negative cable (Refer to AIRBAG SYSTEM ). Personal injury or death may result if the system test is not performed first.

WARNING: Following successful completion of the Airbag System test procedure, the Occupant Classification System Verification Test must be done using a scan tool and the appropriate diagnostic information.