LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Restraints System (Service Information)) >> Passenger Airbag >> Installation >> Deployed Passenger Airbag

Deployed Passenger Airbag

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Passenger Airbag Location
GC0016649Courtesy of DAIMLERCHRYSLER CORP.
NOTE: For deployed passenger airbags, the instrument panel top pad must be replaced.
  1. Clean powder residue from interior of vehicle (Refer to ELECTRICAL/RESTRAINTS - STANDARD PROCEDURE - SERVICE AFTER AN AIRBAG DEPLOYMENT) .
  2. Inspect and transfer all reusable components from the old instrument panel top pad to the new instrument panel top pad.
  3. Position new passenger airbag into instrument panel cavity.
    Fig 2: Passenger Airbag Fasteners
    GC0016650Courtesy of DAIMLERCHRYSLER CORP.
  4. Install the two lower passenger airbag mounting bolts (2). Torque bolts to 11.6 N.m (103 in. lbs.).
  5. Install the four left and right passenger airbag mounting screws (1). Torque screws to 2.8 N.m (25 in. lbs.).
  6. Connect the passenger airbag electrical connector (3).
  7. Install new instrument panel assembly (Refer to BODY/INSTRUMENT PANEL/INSTRUMENT PANEL ASSEMBLY - INSTALLATION) .
WARNING: Do not connect the battery negative cable (Refer to AIRBAG SYSTEM ). Personal injury or death may result if the system test is not performed first.
scientia non olet · About LEMON Manuals