Diagnostic Test

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

VERIFY DTC IS ACTIVE
1. Turn the ignition on.
2. Using a scan tool, read and record DTCs.
3. Using a scan tool, read and record Environmental Data (EV Data).
4. Using a scan tool, erase DTCs.
5. Cycle the ignition switch.
6. Using a scan tool, read DTCs.
  Does this DTC reset?
  
  Yes
  - Replace the Dynamics Sensor in accordance with the Service Information.
  - Perform ABS VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Antilock Brake (ABS) - Standard Procedure .
  No
  - Perform the ABS INTERMITTENT CONDITION TEST. See DTC-Based Diagnostics/MODULE, Antilock Brake (ABS) - Standard Procedure .