Diagnostic Test

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

DTC STATUS IS ACTIVE
NOTE: The vehicle must remain stationary for 20 minutes before proceeding with this diagnostic procedure.
1. Turn the ignition on.
2. With the scan tool, read and record TPM Module DTCs.
3. With the scan tool, erase TPM Module DTCs.
4. Test drive the vehicle at a speed greater than 24 km/h (15 mph) for 20 minutes in order to receive TPM Sensor data and allow for the system to update.
5. With the scan tool, select View DTCs in the TPM Module.
  Is the DTC status Active at this time?
  
  Yes
  - Go to step 2
  No
  - Go to step 3
TIRE PRESSURE MONITORING (TPM) SENSOR INTERNAL FAULT ACTIVE
1. Turn the ignition on.
2. With the scan tool, select Data Display for the TPM Module and locate the following for each TPM Sensor:
- Tire Pressure Sensor HW Fault
- Tire Temperature Sensor HW Fault
- Tire Acceleration Sensor HW Fault
INTERMITTENT TIRE PRESSURE MONITORING (TPM) SENSOR DTC
1. The conditions necessary to set this DTC are not present at this time.
2. Perform any Technical Service Bulletins that may apply to this condition.
3. With the scan tool, clear DTCs in the Tire Pressure Monitoring (TPM) Module.
4. Have the vehicle remain stationary for 20 minutes.
5. With the scan tool, select View DTCs in the Tire Pressure Monitoring (TPM) Module.
  Does the DTC reset or is the status Active for this DTC?
  
  Yes
  - Install a new Tire Pressure Monitoring (TPM) Module in accordance with the Service Information. Refer to Tires and Wheels/Tire Pressure Monitoring/MODULE, Tire Pressure Monitoring (TPM) - Removal
  - Perform the TPM VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Tire Pressure (TPM) - Standard Procedure .
  No
  - Test complete.
  - Perform the TPM VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Tire Pressure (TPM) - Standard Procedure .