LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 332 (Transfer Case BW 44-40 (Service Information)) >> SEAL, Input Shaft >> Removal >> Rear

SEAL, Input Shaft: Removal: Rear

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Holder 6958 And Rear Output Flange
GC0095862Courtesy of CHRYSLER LLC
  1. Remove the rear propeller shaft. Refer to Differential and Driveline/Propeller Shaft - Removal
  2. Install Holder 6958 (1) onto the rear output flange (2).
  3. Remove the rear output flange nut from the input shaft.
    Fig 2: Rear Output Flange Washer
    GC0095863Courtesy of CHRYSLER LLC
  4. Remove the rear output flange washer (1)
    Fig 3: Outer Rear Output Shaft Seal
    GC0095864Courtesy of CHRYSLER LLC
  5. Remove the outer rear input shaft seal (1)
    Fig 4: Rear Output Flange
    GC0095865Courtesy of CHRYSLER LLC
  6. Remove the rear output flange (1) from the input shaft.
  7. Remove the inner rear input shaft seal.
scientia non olet · About LEMON Manuals