LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 332 (Transfer Case BW 44-40 (Service Information)) >> Fluid >> Standard Procedure >> Fluid Check

Fluid Check

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle.
    Fig 1: Transfer Case And Drain Plug
    GC0095857Courtesy of CHRYSLER LLC
  2. Clean the area around the transfer case plugs(2) and (3).
    NOTE: Inspect all the transfer case plug seals and replace as necessary.
  3. Remove the transfer case fill plug (3).
  4. Remove the transfer case drain plug (2) and allow the transfer case lubricant to drain into a suitable container.
  5. When the fluid has stopped draining, install the drain plug (2) and tighten to 23 Nm (17 ft. lbs.).
  6. Using the fill hole (3), fill the transfer case with 1.0 L +/- 0.05 L (2.11pint +/- 0.11 pint) of fluid. Refer to Vehicle Quick Reference/Capacities and Recommended Fluids - Specifications .
  7. Install the fill plug (3) and tighten to 23 Nm (17 ft. lbs).
scientia non olet · About LEMON Manuals