Diagnostic Test
WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK IF TCM IS FLASHABLE NOTE: Controller is programmed with generic software and will not allow the correct vehicle Powertrain management.
- With the scan tool, record the vehicles controller part number.
- Select Use Controller Part Number under the Flash Tab.
- Flash the controller with the correct software.
Were you able to update (flash) the controller successfully?
Yes
- Test Complete.
- Perform NAG1 TRANSMISSION VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Transmission Control (TCM) - Standard Procedure .
No
- Using the schematics as a guide, check the Transmission Control Module (TCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the TCM in accordance with the Service Information. Refer to Electrical/Electronic Control Modules/MODULE, Transmission Control - Description
- Perform NAG1 TRANSMISSION VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Transmission Control (TCM) - Standard Procedure .