Sensor-Front Wheel Speed: Removal: RWD

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support vehicle. (Refer to LUBRICATION & MAINTENANCE/HOISTING - STANDARD PROCEDURE)

Fig 1: Locating Speed Sensor Cable Routing Clip At Brake Tube Bracket
Courtesy of DAIMLERCHRYSLER CORP.
Remove sensor cable routing clip (2) from brake hose bracket (3).

Fig 2: Releasing Wheel Speed Sensor Connector
Courtesy of DAIMLERCHRYSLER CORP.

NOTE: To release sensor connector from body wiring harness connector (1) in following step, move retaining clip (2) as indicated here, then pull sensor connector (3) outward.

Fig 3: Locating Speed Sensor Cable Routing Clip At Brake Tube Bracket
Courtesy of DAIMLERCHRYSLER CORP.
Remove sensor connector (1) from body wiring harness connector (4).

Fig 4: Wheel Speed Sensor At Front Knuckle
Courtesy of DAIMLERCHRYSLER CORP.
Remove screw (3) fastening wheel speed sensor to knuckle (1). Pull sensor head (4) out of knuckle.
Remove wheel speed sensor cable routing clip (2) from brake hose routing bracket (5).