LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 329 (Rear Suspension) >> SHOCK ABSORBER, Suspension >> Removal >> Standard

SHOCK ABSORBER, Suspension: Removal: Standard

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle. Refer to Vehicle Quick Reference/Hoisting - Standard Procedure
    Fig 1: TIRE AND WHEEL MOUNTING
    GC0079683Courtesy of CHRYSLER LLC
  2. Remove wheel mounting nuts (3), then tire and wheel assembly (1).
  3. Position under-hoist utility jack or jack stand under outer spring link adding just enough support to keep suspension from going into full-rebound when shock absorber mounting bolts are removed.
    Fig 2: SHOCK MOUNTING - LOWER
    GC0079751Courtesy of CHRYSLER LLC
  4. Remove shock absorber (1) lower mounting bolt (2) and nut (4).
    Fig 3: SHOCK MOUNTING - UPPER
    GC0079750Courtesy of CHRYSLER LLC
  5. Remove shock absorber (1) upper mounting bolts (2).
  6. Remove shock absorber (4).
scientia non olet · About LEMON Manuals