Right Link

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support vehicle. Refer to Vehicle Quick Reference/Hoisting - Standard Procedure

Fig 1: TIRE AND WHEEL MOUNTING
Courtesy of CHRYSLER LLC
Remove wheel mounting nuts (3), then rear tire and wheel assembly (1).

Fig 2: WSS ROUTING ALONG LEFT TOE LINK
Courtesy of CHRYSLER LLC
If equipped, remove wheel speed sensor cable (2) from toe link.

Fig 3: REAR TOE ADJUSTMENT BOLT NUT
Courtesy of CHRYSLER LLC
While holding toe adjustment cam bolt from rotating, remove nut (3) securing toe link at crossmember (1).

Fig 4: TOE LINK MOUNTING
Courtesy of CHRYSLER LLC
Slide cam bolt (2) rearward out of crossmember and link (1).
Remove mounting bolt (3) and nut at knuckle.
Remove toe link (1).