STABILIZER BAR, Front: Removal: Rear-Wheel-Drive

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Screws & Front Stabilizer Bar Heat Shield

Courtesy of CHRYSLER LLC

Raise and support vehicle. Refer to Vehicle Quick Reference/Hoisting - Standard Procedure .
Remove belly pan. Refer to Frame and Bumpers/Under Body Protection/BELLY PAN - Removal .
On each side of vehicle, remove screws (1) fastening stabilizer bar heat shield (3). Remove heat shield.

Fig 2: Identifying Front Stabilizer Bar Bushing Retainer & Bolts
Courtesy of CHRYSLER LLC
On each side of vehicle, remove bolts (2) fastening stabilizer bar isolator retainer (1) in place.

Fig 3: Identifying Stabilizer Bar Bushing & Retainer Halves
Courtesy of CHRYSLER LLC
On each side of vehicle, remove retainer halves (1) (2) from around stabilizer bar isolator (3).

Fig 4: Identifying Bushing & Stabilizer Bar
Courtesy of CHRYSLER LLC
Utilizing slit, remove each isolator (1) from stabilizer bar (2).

Fig 5: Link Ball Joint At Stabilizer Bar
Courtesy of CHRYSLER LLC
On each side of vehicle, remove nut (5) fastening stabilizer link (3) to stabilizer bar (4). Slide link ball joint stem (1) from bar, then remove bar from vehicle.