Hub And Bearing: Removal: AWD

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Tire And Wheel Mounting

Courtesy of CHRYSLER LLC

Raise and support vehicle. Refer to Vehicle Quick Reference/Hoisting - Standard Procedure
Remove wheel mounting nuts (3), then tire and wheel assembly (1).

Fig 2: Axle Shaft Hub Nut
Courtesy of CHRYSLER LLC
While a helper applies brakes to keep hub from rotating, remove hub nut (1) from the axle half shaft (2).
Access and remove front brake rotor. Refer to Brakes/Hydraulic/Mechanical/ROTOR, Brake - Removal

Fig 3: Identifying Bolts, Fastening Hub, Bearing & Axle Half Shaft
Courtesy of CHRYSLER LLC
Remove four bolts (3) fastening hub and bearing (2) to knuckle.
Slide hub and bearing (2) off axle half shaft (1) and knuckle.