Section 323 (Driveshaft): Installation: Front
WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - PROPELLER SHAFT ASSEMBLY |
| 2 - BOLTS |
- Install propeller shaft (1) into position.
- Starting at transfer case end, align index marks placed upon removal and loose-install new propeller shaft-to-transfer case flange bolts.
- Align index marks at front axle end of shaft, and loose-install new propeller shaft-to-front axle flange bolts.
- Torque propeller shaft-to-transfer case and axle flange bolts (2) to 61 N.m (45 ft. lbs.).
1 - HEAT SHIELD - Install propeller shaft heat shield.
- Lower vehicle.