LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 318 (42RLE Automatic Transmission (Service Information)) >> CABLE, Shift >> Removal >> Column Mount

Column Mount

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the shifter in PARK
  2. Raise the vehicle.
    Fig 1: Gearshift Cable, Manual Valve Lever & Mounting Bracket
    GC0095808Courtesy of CHRYSLER LLC
  3. Remove the gearshift cable retaining clip (4) (if equipped).
  4. Disconnect the gearshift cable (1) eyelet at transmission manual shift lever (3) and pull the cable out of the mounting bracket (2).
  5. Lower the vehicle.
  6. Remove the instrument panel side trim.
  7. Remove the knee bolster fasteners, and the knee bolster.
  8. If equipped, disconnect the trunk release harness connector from the trunk release switch on the knee bolster.
    Fig 2: Reinforcement I/P Steering Column
    GC0080510Courtesy of CHRYSLER LLC
  9. Remove the screws (3), and the instrument panel steering column cover reinforcement (1).
    Fig 3: Identifying Silencer Panel
    GC0095831Courtesy of CHRYSLER LLC
  10. Remove the silencer panel fasteners and silencer panel (1).
    Fig 4: Identifying Shift Cable, Shift Bracket & Tie Strap
    GC0095793Courtesy of CHRYSLER LLC
  11. If equipped, remove the tie strap (1) that secures the shift cable (3) to the shift bracket (2).
    Fig 5: Shift Cable At Column
    GC0080520Courtesy of CHRYSLER LLC
  12. Disconnect the shift cable (2) to the shift mechanism (1).
  13. Disconnect the shift cable from to cable bracket (3).
    Fig 6: Identifying Shifter Cable Routing
    GC0095832Courtesy of CHRYSLER LLC
  14. Remove the shifter cable grommet (3) from the opening in the dash panel (4), and remove the shifter cable.
scientia non olet · About LEMON Manuals