INSULATOR, Engine Mount, Front: Removal: AWD

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: HEAT SHIELD 5.7L AWD LEFT

Courtesy of CHRYSLER LLC

1 - HEAT SHIELD

2 - BOLT

Disconnect negative battery cable.
Raise vehicle.
For the left front engine mount insulator, remove the heat shield (1).

Fig 2: HEAT SHIELD 5.7L AWD RIGHT
Courtesy of CHRYSLER LLC

1 - HEAT SHIELD

2 - BOLT
Remove the generator support bracket.
For the right front engine mount insulator, remove the heat shield (1).

Fig 3: HYDROMOUNT 5.7L AWD LEFT
Courtesy of CHRYSLER LLC

1 - HYDROMOUNT

2 - BOLT
For the left front engine insulator, remove the insulator to frame fasteners.

Fig 4: HYDROMOUNT 5.7L AWD RIGHT
Courtesy of CHRYSLER LLC

1 - HYDROMOUNT

2 - BOLT

3 - STUD
For the right front engine insulator, remove the insulator to frame fasteners.
Raise engine using suitable jack.
Remove engine mount to insulator bolts on both the right and left side of the engine, and the stud on the right side.
Remove the engine hydromounts from both sides of the engine.