Main Bearing Journal Diameter (Crankshaft Removed)
WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
With the crankshaft removed from the cylinder block clean the oil off the main bearing journal.
Determine the maximum diameter of the journal with a micrometer. Measure at two locations 90° apart at each end of the journal.
The maximum allowable taper is 0.008 mm (0.0004 inch.) and maximum out of round is 0.005 mm (0.0002 inch). Compare the measured diameter with the journal diameter specification (MAIN BEARING SELECTION CHART - 5.7L ). Select the inserts required to obtain the specified bearing-to-journal clearance.