LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 316 (Charging System (Service Information)) >> Generator >> Removal >> 2.7L

Section 316 (Charging System (Service Information)): Generator: Removal: 2.7L

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: ALTERNATOR ELECTRICAL CONNECTION
GC0080018Courtesy of CHRYSLER LLC
WARNING: DISCONNECT NEGATIVE CABLE FROM BATTERY BEFORE REMOVING BATTERY OUTPUT WIRE (B+ WIRE) FROM GENERATOR. FAILURE TO DO SO CAN RESULT IN INJURY OR DAMAGE TO ELECTRICAL SYSTEM.
  1. Disconnect and isolate negative battery cable at battery.
  2. Remove generator drive belt. Refer to Cooling/Accessory Drive/BELT, Serpentine - Removal .
  3. Unsnap plastic protective cover (3) from B+ mounting stud.
  4. Remove B+ terminal mounting nut (2) and B+ terminal (1) at rear of generator.
  5. Disconnect field wire electrical connector (4) by pushing on connector tab.
    Fig 2: GENERATOR 2.7L
    GC0080019Courtesy of CHRYSLER LLC
  6. Remove mounting bolts (1) from generator (2).
  7. Remove generator (2) from engine compartment.
scientia non olet · About LEMON Manuals